TM 10-4610-215-24
TM 08580A-24/2
1. REMOVE DUST CAP (1) FROM TOP OF SPRING
CHAMBER (2). REMOVE RELEASE STUD ASSEMBLY
FROM SIDE SLEEVE (3) BY REMOVING RELEASE
STUD NUT (4) AND WASHER (5) FROM RELEASE
STUD (6) AND SLIDING RELEASE STUD OUT OF SLEEVE.
2. INSERT RELEASE STUD (6) THROUGH OPENING
(WHEN DUST CAP WAS REMOVED) OF SPRING
CHAMBER (2). AND INTO THE PRESSURE PLATE (7)
TURN RELEASE STUD (6) 1/4 TURN (CLOCKWISE) IN-
TO PRESSURE PLATE (7) TO SECURE CROSSPIN (8)
IN CROSSPIN AREA OF PRESSURE PLATE (7). THEN
LOCK RELEASE STUD INTO MANUAL RELEASE
POSITION .
3 PLACE PREVIOUSLY REMOVED RELEASE STUD
WASHER (5) AND NUT (4) ON RELEASE STUD (6) AND
HAND TIGHTEN THE NUT ONTO RELEASE STUD
Figure 3-49. Trailer Brake Caging Air Chamber Compression Spring (ARMY)
3-191