TM 10-4610-229-24
2-41. BELT HOUSING/BOOST PUMP REPLACEMENT/REPAIR (CONT)
10
Remove pump and belt housing from bellhousing.
11
Remove belt drive gear from belt.
12
Remove four nuts and flatwashers. Remove belt housing from tombstone adapter.
13
Remove belt from belt housing.
14
Remove four bolts. Remove belt housing adapter from belt housing.
b.
Inspection
1
Inspect belt housing parts. Replace damaged parts.
2
Inspect pump. Replace as required.
c.
Assembly and Installation
1
Install belt housing adapter on belt housing. Install four bolts.
2
Install belt in belt housing.
3
Install belt housing on tombstone adapter. Install four nuts and flatwashers.
4
Insert three bolts and washers into unthreaded holes of belt drive gear.
5
Install belt drive gear in belt.
6
Install pump and belt housing on bellhousing.
7
Aline holes in belt drive gear with threaded holes of coupling. Tighten nuts.
8
Install eight shims and vent screen on tombstone adapter. Install four flatwashers, lockwashers, and bolts.
WARNING
When tapping starter, make sure engine stop is in the STOP position. If not, engine could start,
causing injury to personnel.
9
Tap starter. Check operation of drive belt.
2-97