TM 10-4610-229-24
3-11. CYLINDER HEAD/CYLINDER REPLACEMENT/REPAIR (CONT)
5
Install cylinder head (subpara d).
6
Crank engine past top dead center (tdc).
7
Remove cylinder head (subpara a).
8
Remove solder wire.
NOTE
Piston clearance is the space between cylinder head and the flat surface top of piston, with piston
at tdc. Piston clearance should be 0.9-1.2 mm (0.035-0.047 in. Add shims to increase clearance.
Remove shims to decrease clearance.
9
Using micrometer gage, measure thickness of flattened solder wire. Correct as needed.
10
Install cylinder head (subpara d).
d.
Cylinder Head Installation
1
Install valves as required (para 3-12).
2
Clean cylinder head.
3
Install cylinder head gasket.
4
Install cylinder head.
NOTE
Cylinder head nuts should be torqued in a crisscross pattern.
5
Install four cylinder head nuts. Torque nuts 36-39 ft lb.
6
Install rocker arm/push rods (para 3-13).
7
Install injection nozzle (para 3-9).
8
Install exhaust pipe/muffler (para 2-32).
9
Install air filter housing (para 2-28).
10
Install fuel tank (para 2-26).
3-27
