TM 10-4610-232-12
c. Replace any cable that is shorted, does not show continuity from end to end on any wire, has damaged connectors
or cut insulation.
d. Install new dust caps and chain by inserting the S-hook (8) through the eyelet on the cap or plug and through the
end link of the chain. Use a pliers to squeeze the S-hook closed.
e. Install another S-hook in the eyelet on the connector boot (9) and through the open link on the cap or plug chain
Use a pliers to squeeze the S-hook shut.
f. Install the clamp (6) on the cable and install washer (5) and pop rivet (4) to secure strap (2) to cable (3).
INSTALLATION.
a. Remove dust cap from van connection or the other cable connection by turning the cap 1/4 turn
counterclockwise.
b. Install cable on van connection by inserting it into the receptacle and turning the connector (1) nut 1/4 turn
clockwise.
4-96
