TM 10-4610-232-12
REMOVAL.
a. Disconnect cable assembly connector P29 (Figure 4-32) from power source connector J29.
b. Remove four screws (1) and pull outlet box (2) (with receptacle (6) and wires attached) out of housing (36).
c. Remove two screws (10) and pull plate (11) out of housing (36).
d. Remove twocapscrews (12), two Iockwashers (13) and two washers (14).
e. The entire assembly is now free and can be moved to a disassembly area. Ground wire (4) is also free of housing
(36).
DISASSEMBLY.
a. Tag and disconnect three wires (15) and ground wire (4) from receptacle by removing four screws (3).
b. Remove assembled parts (2, 9, 5 and 6) and gasket (7). If necessary, remove screw (8) and dust cover (9).
c. Remove two screws (5) and receptacle (6).
d. Disconnect and tag wires leading to lamp housing (20).
e. Unscrew lens (16) and remove lamp (17) by turning it counterclockwise.
f. Remove locknut (18), Iockwasher (19), lamp housing (20) and washers (21). Remove gasket (22).
NOTE
There are three pushbutton switches in housing. The procedure for removing each is
the same with the following exception: One wire connects the top switch to the
middle switch. This wire must be disconnected when removing the top two switch
assemblies.
g. Remove two screws (23) and pull plate (24) forward. Disconnect and tag wires to pushbutton switch (27),
including the jumper wire on the switch.
h. Remove locknut (25), Iockwasher (26), switch (27), and washers (29). Gasket (30) is now free.
i. Remove the other two pushbutton switches as described above.
j. Loosen nut (31), retainer (32), sealing bushing (33) and locknut (33A), and remove connector (34).
k. Remove cable assembly (35) from the connector parts (31 thru 34).
l. Remove connector parts (31 thru 34) from cable assembly.
R E P A I R .
a. Replace any damaged or unserviceable parts or wires.
b. Replace cable assembly (35) if it does not show continuity from end to end on any wire, or has damaged or cut
insulation.
c. Replace wire markers (para. 4-10).
d. Replace loose or damaged ring tongue terminals (para. 4-10).
REASSEMBLY.
a. Install connector (34) in housing (36). Spray or brush varnish on each wire connection after installing wires.
Change 2 4-139
