TM 10-4610-232-12
4-31. SWITCH PANEL NO. 2. This task covers:
a. Removal
b. Disassembly.
c. Repair.
d. Reassembly.
e. Installation.
INITIAL SETUP.
Tools, see Appx B, Sec Ill, Ref Code (No.):
Equipment Condition:
Tool Kit, General Mechanics Automotive (1)
ROWPU shutdown.
Stripper, Wire (16)
MAIN CIRCUIT BREAKER (CB1) OFF
Terminal Strip Tool (16)
Crimper, Hand Terminal (16)
Materials/Parts:
General Safety Instructions:
WARNING
Suitable Tags
Observe specific Warnings in the text.
Varnish (Appx E, Sec II, Item 73)
Lockwashers (TM 10-4610-232-24P)
Washers (TM 10-4610-232-24P)
WARNING
Make sure electrical power is disconnected before working on unit. Failure to do so
could result in serious injury or death from electrical shock.
WARNING
Do not wear watches, rings or dog tags when working on electrical components.
NOTE
Tag all wires before disconnecting.
NOTE
Remove or install terminal board connections and components as described in para.
4-10.
REMOVAL
a.
b.
c.
d.
e.
NOTE
The internal components of the switch panel enclosure are shown on Figure 4-34.
They are omitted in Figure 4-33 for clarity.
Unscrew connectors (1, 2 and 3, Figure 4-33).
Loosen eight capscrews (4) and cover clips (5) and open cover (6).
Tag and remove wiring harness (7) from terminal strip (17) (para. 4-10).
Unscrew connector nut (8). Retainer (9) and bushing (10) are now loose on wire (7).
Remove wire (7) with items (8, 9 and 10).
f. Remove cable adapter with sealing washer (11) by removing conduit nut (12).
g. Remove fourcapscrews(13), Iockwashers (14) and washers (15) and remove panel assembly (16).
4-141
