TM 10-4610-232-12
i. Remove wiring harness (31) as follows:
(1) Tag and disconnect wires to terminal board (36).
(2) Remove four capscrews (32), nuts (33), Iockwashers (34) and washers (34A).
(3) Remove wiring harness (31) and gasket (35).
NOTE
Be sure to note the location of jumper.
j. Loosen capscrew (37) and remove retainer (38), end plate (39), terminal strip (40) and jumpers (41).
k. Remove eighteen terminal strips (40), if required. Refer to para. 4-10 for terminal board procedures.
NOTE
If terminal strips are being replaced, unsnap the terminal marker for use on the
replacement terminal.
l. If necessary, remove two capscrews (43), Iockwashers (44) and rail (45).
m. If necessary, remove four capscrews (46), Iockwashers (46A) and washers (466). Remove sub panel (47).
NOTE
If tags have been lost during disassembly, refer to wiring Table 4-3 for point to point
location.
Table 4-3. Wiring Table
4-144 Change 2
