TM 10-4610-239-10
TM 08580B-10/1
LEGEND
1.
Lens Cap
2.
Lamp Bulb
3.
Gasket Washer
4.
Lamp Base Holder
Figure 3-15. Switch Indicator Lamp Replacement
b.
Installation.
(1)
Replace bulb (2) with lamp puller in Storage Box No. 2.
(2)
Cover the lamp base holder (4) with gasket washer (3).
NOTE
Clean lens cap before reassembly.
(3)
Screw on lens cap (1).
(4)
Test new lamp using the TEST INDICATOR LIGHTS switch on left side of control box.
3-11.
REPLACING LAMP IN THE PANEL LIGHT (refer to fig. 3-16)
a.
Removal.
(1)
Using flat-tip screwdriver, loosen setscrew (1), observing position of shield.
(2)
With your fingers, unscrew guard (2), lens (3), and bulb (4) from lamp base (5).
NOTE
Lens must be cleaned before installation.
3-30