TM 10-4610-239-24
TM 08580B-24/3
Section I. LUBRICATION INSTRUCTIONS
Refer to Lubrication Instructions LO 10-4610-239-12/LI 08580A-12.
Section II. REPAIR PARTS; SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC
EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT
2-1. COMMON TOOLS AND EQUIPMENT. For authorized common tools and equipment, refer to the Modified Table
of Organization and Equipment (MTOE) applicable to your unit. USMC, refer to Table of Authorized Material (TAM)
applicable to your unit.
2-2. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT. Refer to TM 10-4610-239-24P and the Maintenance
Allocation Chart in Appendix B of this manual.
2-3. REPAIR PARTS. Repair parts are listed and illustrated in the repair parts and special tools list, TM 10-4610-239-
24P, covering unit, direct support, and general support maintenance for this equipment.
Section III. SERVICE UPON RECEIPT
2-4. SITE AND SHELTER REQUIREMENTS. When not in use, the ROWPU does not require special siting or shelter.
If shelter is available, storing the ROWPU under cover will minimize routine maintenance. For site and shelter
requirements during routine operation, refer to TM 10-4610-239-10.
2-5. SERVICE UPON RECEIPT OF MATERIAL.
a. Checking Unpacked Equipment.
(1)
Inspect the equipment for damage incurred during shipment. If the equipment has been damaged, report the
damage on DD Form 6, Packaging Improvement Report. Marine Corps personnel refer to MCO 4430.3.
(2)
Check the equipment against the packing slip to see if the shipment is complete. Report all discrepancies in
accordance with the instructions of DA Pam 738-750. Marine Corps personnel refer to TM 4700-15/1.
(3)
Check to see whether the equipment has been modified.
b. Deprocessing Unpacked Equipment.
WARNING
Drycleaning solvent, AA 711 I & II, used to clean parts is potentially dangerous to
personnel and property. Avoid repeated and prolonged skin contact by wearing rubber or
nonporous gloves when handling the solvent or material wet with Drycleaning solvent.
Wash hands immediately after exposure with soap and water and use a lanolin based
skin cream to prevent skin drying. Do not use near open flame or excessive heat. Flash
point of solvent is 100 (38 ). Do not work with solvent in a closed room. Be sure
F
C
there is good ventilation or the solvent vapors will build up in the air and become a
poisonous mixture which can cause physical injury or even death.
2-2
