TM 10-4610-239-24
TM 08580B-24/3
REMOVAL.
WARNING
Compressed air can blow dust into eyes. Wear eye protection and turn
drain cock T-handle slowly to avoid a sudden rush of air when releasing
reservoir pressure.
a.
Turn drain cock T-handle (1) slowly counterclockwise to release air pressure from reservoir.
NOTE
Ensure that airflow from reservoir has stopped before closing drain cock.
b.
Turn drain cock T-handle (1) clockwise to close drain cock.
c.
Disconnect tubing (2) from elbow (3).
d.
Disconnect two hoses (4) from two adapter fittings (5).
e.
Remove two nuts (6), two cap screws (7), and anchor tee (8) with elbow (3) and two adapter fittings (5) attached.
f.
Remove elbow (3) and two adapter fittings (5).
INSTALLATION.
NOTE
Apply antiseize tape to all male fittings before installation.
a.
Install two adapter fittings (5) on anchor tee (8).
b.
Install elbow (3) on anchor tee (8).
c.
Position anchor tee (8) with elbow (3) and two adapter fittings (5) attached and install two cap screws (7) and nuts
(6).
d.
Connect two hoses (4) to two adapter fittings (5).
e.
Connect tubing (2) to elbow (3).
f.
Check that drain cock T-handle (1) is turned fully clockwise.
g.
Connect air hoses to towing vehicle. Refer to TM 10-4610-239-10.
2-102
