TM 10-4610-239-24
TM 08580B-24/3
INSTALLATION. (Cont)
b.
Install nut (9).
c.
Check that drain cock T-handle (1) is turned fully clockwise.
d.
Connect air hoses to towing vehicle. Refer to TM 10-4610-239-10.
e.
Start engine of towing vehicle and wait for towing vehicle air compressor to fully charge flatbed cargo trailer brake
system. Refer to Operator's Manual for towing vehicle.
f.
Uncage compression springs on all four air chambers. Refer to paragraph 2-47.
TEE
NOTE
There are two tees in the airbrake system. Both are installed the same.
One is shown.
a.
Position tee (14) and install three sleeve nuts (13).
b.
Check that drain cock T-handle (1) is turned fully clockwise.
c.
Connect air hoses to towing vehicle. Refer to TM 10-4610-239-10.
d.
Start engine of towing vehicle and wait for towing vehicle air compressor to fully charge flatbed cargo trailer brake
system. Refer to Operator's Manual for towing vehicle.
e.
Uncage compression springs on all four air chambers. Refer to paragraph 2-47.
TUBING
NOTE
The airbrake system tubing is in sections connecting the hose assembly
All are installed in a similar manner. One is shown.
a.
Position loop clamp (11) on stud (12) and install nut (9).
b.
Position tubing (10) on loop clamp (11).
c.
Install sleeve nut (13).
d.
Working at other end of tubing section, install sleeve nut (3) and sleeve (2).
2-99
