TM 10-4610-239-24
TM 08580B-24/3
REMOVAL.
a.
Remove four screws (1), star washers (2), cover (3), and gasket (4) from conduit box (5).
b.
Pull slack in three wire bundles (6) from conduit box (5). Remove twine (7) and electrical tape
(8) from each bundle.
NOTE
There are three wire bundles in conduit box. All are disassembled the same. One is shown.
Tag wires by set before removal.
c.
Remove nut (9), lockwasher (10), flat washer (11), two wire lugs (12), and screw (13).
d.
Remove three screws (14), star washers (15), nut (16), terminal lug (17), and stud (23) from terminal box (5).
e.
Disconnect connector (18) from elbow (19).
f.
Carefully pull four wires (20) from conduit box (5) and elbow (19).
g.
Remove connector (18) from cable (22).
h.
Remove elbow (19) from conduit box (5).
INSTALLATION.
NOTE
Apply antiseize tape to all male pipe threads before installation.
a.
Install elbow (19) on conduit box (5).
b.
Install three screws (14), star washers (15), and stud (23) and position connector (18) on cable (22).
c.
Carefully pull four wires (20) through elbow (19) into conduit box (5).
d.
Install cable connector (18) on elbow (19).
e.
Install terminal lug (17) and nut (16) on stud (23).
2-300
