TM 10-4610-239-24
TM 08580B-24/3
DISASSEMBLY. (Cont)
o.
Remove two nuts (28) and washers (29).
p.
Remove cotter pin (30) and clevis pin (31). Discard cotter pin.
q.
Remove screw (32) and cap (33).
CLEANING.
WARNING
Drycleaning solvent AA 711 TYPE I & II is highly toxic and can ignite
organic materials, nitrates, carbides, and chlorates. Wear eye, skin, and
respiratory protection. Use in well-ventilated area.
a.
Using drycleaning solvent and stiff-bristled brush, scrub outside of chamber, adapter, and
housing assembly. Allow to air dry.
b.
Using drycleaning solvent and stiff-bristled brush, scrub push rod arm, clevis, and clevis pin.
Scrub stud assembly, clamps, and all nuts, bolts, and washers. Allow to air dry.
c.
Using solution of mild soap and water, wash all remaining pats and insides of chamber, adapter,
r
and housing assembly. Wipe dry with clean, lint-free cloth.
INSPECTION.
a.
Inspect all threaded items for damaged heads or threads or deformity. Replace as required.
b.
Inspect spring seat, plates, clamps, and washers for bends, cracks, or burrs. Replace as required.
c.
Inspect springs, chamber, adapter, and housing assembly for cracks or deformity. Replace as
required.
d.
Inspect diaphragms for tears, worn areas, brittleness, cracking, or deformity. Replac as required.
e
e.
Inspect screws for presence of nylon inserts in shaft. Inspect nylon inserts for evidence of
damage to threads. Replace as required.
f.
Inspect stud assembly for damaged or missing locking pins. Replace as required.
g.
Inspect plug for brittleness, cracking, deformed or missing tab, or loose fit. Replace as required.
ASSEMBLY.
a.
Install plate (26) and screw (27) on push rod adapter (25).
b.
Insert push rod adapter (25) through hole in adapter (13) and hold it in place whileurning adapter over.
t
3-93
