TM 10-4610-241-10
TO 40W4-13-41
2-6.
TRAILER ASSEMBLY AND PREPARATION FOR USE (Models WPES-10 and
H-95181) - cont.
NOTE
TWO PERSONNEL OPERATING BOTH LEVELING JACKS ARE
REQUIRED TO RAISE THE TRAILER.
9.
POSITION CRANK HANDLE (2) ON JACK (4) AND TURN
HANDLE CLOCKWISE TO LOWER JACK PAD (5).
CONTINUE TO LOWER BOTH FRONT JACKS UNTIL
WEIGHT OF TRAILER RESTS ON JACKS INSTEAD OF
TOWING VEHICLE AND LUNNETE IS CLEAR OF PINTLE.
11.
REMOVE SAFETY PIN (11) AND CRANK HANDLE (12)
FROM REAR OF JACK SUPPORT BRACKET (13).
10.
REPLACE CRANK HANDLE (2) ON REAR OF JACK SUPPORT
BRACKET (3); INSTALL SAFETY PIN (1).
12.
POSITIONCRANK HANDLE (12) ON JACK (14) AND TURN
HANDLE COUNTERCLOCKWISE TO RETRACT JACK UNTIL
JACK PAD (15) 15 CLEAR OF SECUREMENT PLATE (16)
ROUND BAR.
2-40 Change 2
Figure 2-19. Trailer Preparation for Use (Sheet 3 of 5)
(Models WPES-10 and H-9518-1)
