TM 10-4610-241-10
TO 40W4-13-41
2-7. ROWPU ASSEMBLY AND PREPARATION FOR USE - cont.
d.
Install Control Panel Quick Disconnect Fittings. Refer to figure 2-25. Using pipe wrench from
storage chest, install quick disconnect fittings and components as follows:
NOTE
During installation, apply antiseize tape (from storage chest) to pipe threads
of quick disconnect fittings.
(1)
Unscrew caps from WASTE, VENT VESSELS, and BACKWASH water hose couplings on
control panel.
(2)
Install Z-inch male quick disconnect fittings on WASTE, VENT VESSELS, and
BACKWASH water hose couplings oncontrol panel.
(3)
Remove caps from PRODUCT WATER, BRINE, and RAW water hose couplings on control
panel.
(4)
Install 1 1/2-inch male quick disconnect fittings on PRODUCT WATER, BRINE, and
RAW water hose couplings on control panel.
Figure 2-25. Control Panel Quick Disconnect Fittings.
2-50.4 Change 2
