TM 10-4910-241-24
TO 40W413-42
2-24.1 OCEAN INTAKE STRUCTURE REPAIR (MODELS H-9518-1, H-9518-2 AND
H-9619-3) - continued.
(7)
(8)
(8)
Remove the fitting (12), elbow ( 13) bushing ( 14), and nipple (15) in succession from the top of the
wellpoint assembly (I) by turning counterclockwise.
NOTE
It may be necessary to hold the top of the wellpoint with a wrench to remove the bushing (14) and
nipple (15).
If the boot is on, remove the hose clamp (16) at the bottom of the wellpoint (17) and remove the boot
(18).
Remove the cap (19) and gasket (20) on the top of the wellpoint (I 9) by holding the bottom and
turning counterclockwise.
(9)
(10)
(11)
After the wellpoint is separated, remove the guard (2 1).
Remove the screen (22) from the riser pipe (23).
Remove the wellpoint tip (24) and gasket (25) from riser pipe (23). Use a vise if necessary
2-120.4 Change 1
