TM 10-4610-241-24
TO 40W4-13-42
2-82. WIRING HARNESS (TRAILER) REPLACE (WPES-10 AND H-9518-1).
This task consists of:
a. Removal
b. Installation
c. Test
INITIAL SET-UP:
Tools Required
General Mechanics Tool Kit (Appendix B, Section III, Item 4)
Material/Parts Required
Grease, Silicone (Appendix B, Section II, Item 10)
Grommets (TM 10-46 10-241-24P)
Equipment Condition
Reference
Trailer disconnected from Towing Vehicle (TM 10-4610-241-10).
Light Assemblies disconnected (Paragraph 2-80).
Trailer Cable Assembly disconnected from Wiring Harness (Paragraph 2-82).
a.
Removal.
(1)
Remove nut (l), screw (2) and clamp (3) from wiring harness (7).
NOTE
There are eight clamps (5). holding wiring harness to trailer frame. All are removed the
same. One is shown, the others are similar.
(2)
Remove eigth nuts (4) and clamps (5) from wiring harness (7).
NOTE
There are 11 grommets on the wiring harness. All are removed the same. One is shown,
the others are similar.
(3)
Remove grommets (6) from holes in trailer frame (8).
CAUTION
To prevent damage to wiring harness connectors, use care when pulling harness (7)
through holes in trailer frame.
(4)
(5)
Working from front of trailer frame (8) to rear, pull wiring harness (7) from frame.
As required remove four nuts (9) from connector clamps (10 and 11). Remove clamps from trailer frame
(8).
(6)
As required, remove four nuts ( 12) and screws ( 13) from connector clamps ( 14 and 15). Remove clamps
from trailer frame (8).
2-322 Change 1
