TM 10-4610-241-24
TO 40W4-13-42
2-82.
WIRING HARNESS (TRAILER) REPLACE (MODELS WPES-10 and H-9518-1) - continued.
b.
Installation.
CAUTION
To prevent damage t wiring harness connectors, use care when pushing harness through
holes in trailer frame.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
C.
Test.
(1)
(2)
If removed, position connector clamps (15 and 14) on trailer frame (8) and install four screws (13) and nuts
(12).
If removed, position connector clamps (11 and 10) on trailer frame (8) and install four outs (9).
Lubricate 11 grommets (6) and set aside.
Working from rear of trailer to front, insert wiring harness (7) through holes in frame (8). positioning a
grommet (6) on wiring harness after each pass thru frame.
Work grommets (6) into holes in trailer frame (8).
NOTE
‘here are eight clamps of type (5) holding wiring harncss to trailer framc. All are
installed the same. One is shown, the others are similar.
Position clamps (5) on wiring harness (7) and install nuts (4).
Install clamp (3). screw (2). and nut (1) on wiring harness (15).
Check wiring harness (7) for continuity in accordance with schematic diagram below.
Check wiring harness (7) for shorts by
checking for continuity between any pin and
all other pins. Then repeat this process for
all pins.
2-324 Change 1
