TM 10-4610-244-13
TM 09476B-13/1
4-7
PMCS PROCEDURES (Cont'd).
g.
Following are checks that are common to the entire hypochlorination unit.
(1)
Keep it clean. Dirt, grease, oil, and debris only get in the way and may cover up a serious
problem Clean as you work and as needed.
(2)
Rust and Corrosion. Check hypochlorination unit for rust and corrosion If any bare metal
or corrosion exists, clean, and apply a thin coat of oil Report it to your supervisor
(3)
Bolts, Nuts, and Screws. Check them all for obvious looseness missing, bent, or broken
condition. You can't try them all with a tool, but look for chipped paint bare metal, or rust around
bolt heads. If you find a bolt, nut, or screw you think is loose tighten it or report it to your
supervisor
(4)
Welds. Look for loose or chipped paint, rust, or gaps where parts are welded together. If
you find a bad weld, report it to your supervisor
(5)
Hoses and Fluid Lines. Look for wear, damage, and leaks, and make sure clamps and
fittings are tight. Wet spots show leaks, but a stain around a fitting or connector can also mean a
leak If a leak comes from a loose fitting of connector, tighten It If something is broken or worn out,
report it to your supervisor.
4-8.
SPECIAL INSTRUCTIONS. If equipment must be kept in continuous operation, check and service only those
items that can be checked and serviced without disturbing operation. Make complete checks and services when
hypochlorination unit can be shut down.
4-5
