TM 3-4230-204-12&P
8
9
NOTE
The sealing wire need not be installed if the M11
DECON is used again very soon under combat ready
conditions. The sealing wire should be installed at all
Insert one end of arming pin (12) into lowest hole in thumb lever (10) from
times when DS2 is in the container and a filled nitrogen
the front side, and push in until other end of arming pin (12) touches edge of
cylinder is installed.
thumb lever. Slightly compress ends of arming pin (12) until end of arming
pin (12) enters the uppermost pin hole in the thumb lever (10) and fully
a. Face nozzle (11) away from operator. Straighten sealing wire (13).
insert arming pin (12).
b. Pass end of sealing wire through hole in handle (2) from the left
hand (front) side. Pull wire until lead seal rests against left side of
handle (2).
2-7
