TM 5-3800-205-10-2
AIR TRANSPORT BY C-130 AIRCRAFT - CONTINUED
0017 00
CONFIGURE MACHINE FOR AIR TRANSPORT - CONTINUED
b.
Remove two bolts, washers, and retainer bar. Remove pin from rod end of each lift cylinder. Use puller tool if nec-
essary.
NOTE
Work simultaneously on both load transfer axles and operate hydraulics to extend or retract cylinders as
needed to align mounting holes.
Clean and lubricate pins with antiseize compound (Item 5, WP 0025 00) before they are installed.
c.
Position each load transfer axle at front corner of tank, pivot rod end of cylinder forward, align mounting holes,
and install to axle with mounting hardware (pin, retainer bar, two washers, and bolts) removed from axle in step a.
Tighten bolts securely.
d.
Install each axle to bracket of front of tank with mounting hardware removed in step b (pin, retainer bar, two wash-
ers, and bolts). Tighten bolts securely.
LIFT
CYLINDER
PIN, BOLTS, WASHERS
AND RETAINER BAR
BRACKET
PIN
LOAD
BOLTS, WASHERS, AND
TRANSFER
RETAINER BAR
AXLE
0017 00-13
