TM 5-3800-205-23-3
QUICK-RELEASE VALVE REPLACEMENT - CONTINUED
0014 00
REMOVAL
1.
At rear of water distributor, disconnect hose (1) from fitting (2) at top of quick-release valve (6).
2.
Remove fitting (2) and adapter (3) from quick-release valve (6).
3.
Remove pipe plug (7) from quick-release valve (6).
4.
Remove quick-release valve (6) and adapter (5) from air/hydraulic brake cylinder (4).
1
3
2
4
7
5
6
INSTALLATION
NOTE
Remove old antiseizing tape from male air fittings and apply new tape before connections are made.
1.
Install adapter (5) and quick-release valve (6) on air/hydraulic brake cylinder (4).
2.
Install pipe plug (7) on quick-release valve (6).
3.
Install adapter (3) and fitting (2) to quick-release valve (6).
4.
Connect hose (1) to fitting (2).
5.
Place battery disconnect switch in ON position (TM 5-3800-205-10-2).
WARNING
If machine is parked indoors, DO NOT run engine unless exhaust fumes are vented to the outside. Failure to
follow this warning may cause injury or death due to carbon monoxide poisoning.
6.
Start engine and fully charge air system (TM 5-3800-205-10-2).
7.
Check for air leaks and operation of brakes.
END OF WORK PACKAGE
0014 00-2
