(9) Insert the spark plug cables into the magneto sockets and secure with four connectors.
(10) Position the magneto stop switch wire terminal (18) on the m gneto capacitor terminal and
a
secure with lockwasher and screw.
c. Removal.
(1) Remove the spark plug cables from the magneto (14, fig. 18).
(2) Remove the magneto stop switch wire (18).
(3) Remove the high temperature safety switch by removing the terminal screw (8).
(4) Remove the holddown bolt (15).
(5) Remove the adjusting bolt and remove the magneto from its mounting.
d. Installation.
(1) Position the magneto and gasket (7) in its mounting hole, secure with the holddown bolt (15) and
the adjustment bolt.
(2) Attach the magneto stop switch wire with the screw (8).
(3) Attach the high temperature safety switch wire with the screw.
Section VIII. CHASSIS ELECTRICAL SYSTEM
88. Description
The distributor wiring harness consists of five wiring harnesses which conduct current to the marker and
identification lamps and turn signals. Connectors at the rear of the carrier chassis connect the distributor wiring
to the chassis electrical system.
89. Wiring Harness
a. Removal.
(1) Separate connectors at rear of chassis.
(2) Separate connectors at marker lamps, identification lamps and turn signals.
(3) Release all plastic retainers from harnesses.
(4) Remove harnesses by pulling them through grommets in distributor frame.
b. Cleaning, Inspection, and Repair.
(1) Clean the wiring harnesses with an approved cleaning solvent.
(2) Inspect the insulation for chafing, breakage or deterioration. Replace a wiring harness with badly
deteriorated or chafed insulation. Tape any places where minor damage has occurred.
(3) Clean all connectors and remove any corrosion present.
c. Installation.
(1) Thread the harnesses through the grommets in the distributor frame.
(2) Fasten harnesses in plastic retainers.
(3) Make connections to lamps.
(4) Make connections to carrier wiring at rear of chassis.
90. Turn Signal Switch
a. Removal.
(1) Disconnect turn signal switch wires at flasher unit.
(2) Loosen screw securing clamp securing turn signal switch mounting bracket to steering wheel post,
and remove turn signal switch and wiring harness.
b. Installation.
(1) Position turn signal switch mounting bracket under holddown clamp on carrier steering wheel post
and tighten screw.
(2) Connect turn signal switch wires at flasher unit terminals.
91. Turn Signal Lamps and Brackets
a. Lamp Replacement.
(1) Remove the four screws securing the lens to the lamp body and remove the lens.
(2) Remove the socket-type bulb from the receptacle by pushing in and turning counterclockwise.
(3) Install the bulb by inserting into the receptacle and pressing in while turning clockwise.
(4) Position the lens on the lamp body and secure with four phillips screws.
AGO 6871A
51
