TM 5-4610-218-12
STARTING
STEP 1. PLACE THE HEATER-FAN SWITCH IN EITHER THE
HEATER OR FAN POSITION, DEPENDING ON WHETHER
HEATED AIR OR ONLY CIRCULATION IS DESIRED.
STEP 2. CHECK THE SETTING OF THE THERMOSTAT AND RESET
TO THE DESIRED TEMPERATURE, IF NECESSARY.
STEP 3. CHECK THAT WHITE HEATER INDICATING NIGHTGLOWS.
STOPPING
STEP 1. MOVE HEATER-FAN SWITCH TO CENTER POSITION.
HEATER WILL PURGE AND THEN STOP.
TS 4610-218-12/2-27
Figure 2-27. Starting and stopping personnel heater.
Section III. OPERATION UNDER UNUSUAL CONDITIONS
2-23. General.
c. For operation of the cargo trailer under un-
usual conditions, see TM 9-2330-213-14.
a. The 1500 gph water purification unit, and
supporting equipment, is capable of performing sat-
under unusual conditions, see applicable generator
isfactorily in varied temperatures and weather con-
technical manual.
ditions. Operations other than under normal condi-
tions will require special operation and
NOTE
maintenance precautions when locating, installing,
TM 5-349, Artic Construction, con-
and operating the equipment. The unit will not re-
tains information on artic construc-
move salt from water. For detailed information and
tion which will be important to or-
instructions pertaining to the treatment of poisoned
ganizations in planning water point
water see TM 5-6630-215-12.
layout, constructing protective shel-
b. For operation of the truck under unusual con-
tering, and providing heat for protec-
ditions, see TM 9-2320-209-10.
tion of equipment and peraonnel.
2-57
