TM 5-4610-218-12
d. Installation. Refer to figure 4-103 and in-
4-82. Van Body Bonnet Doors.
stall the bonnet door.
a. General. A door is located on each side of the
bonnet to allow access to the personnel heater and
4-83. Van Body Roof Hatch.
its components. Removal and installation is identi-
a. General. The roof hatch is located above the
cal for both the right and left bonnet doors.
erdlator tank and may be open during fair weather
to facilitate ventilation and give light. It is also
the bonnet door.
used to provide an opening in the event the agitator
c. Clean, Inspect and Repair.
shaft assembly must be removed.
(1) Clean all metal parts with dry cleaning
b. Removal. Refer to figure 4-140 and remove
solvent P-D-680.
the van body roof hatch.
(2) Clean the rubber seals with soap and wa-
c. Clean, Inspect and Repair.
ter.
(1) Clean all metal parts with dry cleaning
(3) Inspect the door hinges for binding.
solvent P-D-680.
(4) Inspect the rubber seals for signs of deteri-
(2) Inspect the roof hatch for dents, dis-
oration.
tortion, and punctures.
(5) Inspect the doors for misalignment or
(3) Inspect all threaded parts for damage.
other damage.
(4) Repair or replace all defective parts. re-
(6) Replace defective rubber seals.
place the roof hatch it it is twisted or bent.
(7) Repair or replace the doors if they are de-
d. Installation. Refer to figure 4-104 and in-
nted or bent.
stall the van body roof hatch.
(8) Repaint the doors if the paint has been
damaged.
Figure 4-103. Van Body Bonnet Door, Installed.
4-157
