TM 5-4610-218-12
4-84. Ventilating Window.
4-86. Stationary Windows.
a. General. A ventilating window is located at
a. General. There are two stationary windows in
the rear door of the van body, It has a crank on the
the van body. One is located in the left sidse upper
inside which is used to open the window outward. It
door, and one in the right side door. The windows
is also equipped with a blackout panel.
are equipped with a metal sliding panel for blackout
b. Removal. Refer to figures 4-105 and 4-106
operation.
and remove the ventilating window.
b. Removal. Refer to figures 4-108 and 4-109
c. Disassembly. Refer to figure 4-107 and disas-
and remove the stationary window.
semble the ventilating window.
c. Disassembly. Refer to figure 4-110 and disas-
d. Clean, Inspect and Repair.
semble the window.
(1) Clean the glass and frame with dry clean-
d. Clean, Inspect and Repair.
ing solvent P-D-680.
(1) Clean the glass and frame with dry clean-
(2) Inspect the glass for cracks or chipped
ing solvent P-D-680.
edges.
(2) Inspect the glass for cracks or chipped
(3) Inspect the frame for cracks and damage.
edges.
(4) Inspect the seal for being stretched out of
(3) Inspect the frame for cracks and damage.
shape or being dried and brittle.
(4) Inspect the seal for being stretched out of
(5) Replace all parts that are unserviceable.
shape or dried out and brittle.
(6) Replace an unserviceable ventilating win-
(5) Replace all parts that are unserviceable.
dow.
(6) Replace an unserviceable stationary win-
e. Reassembly. Refer to figure 4-107 and reas-
dow.
semble the ventilating window.
e. Reassembly. Refer to figure 4-110 and reas-
f. Installation. Refer to figures 4-106 and 4-105
semble the stationary window.
and install the ventilating window.
f. Installation. Refer to figures 4-109 and 4-108
and install stationary window.
Section XXVII. MAINTENANCE OF VAN BODY LIGHT,
REFLECTORS, AND SWITCHES
WARNING
4-86. Van Body Clearance Lights.
a. General. The clearance lights are mounted on
Dry cleaning solvent, P-D-680, used to
the top front and rear, and in pairs mounted at the
clean parts, is potentially dangerous.
upper corners of the front and rear sides of the van
A v o i d repeated and prolonged
body. The top lights in front and front sides have
breathing of the vapors and skin con-
amber lenses and the lower ones have amber black-
tact with the liquid. Do not use near
open flame or excessive heat. Use in a
out lenses. The top lights at the rear and rear sides
have red lenses and the lower ones have red black-
well-ventilated area. The flash-point
of P-D-680 is 100-128 F (28-59C).
out lenses. All clearance lights are 24 volt.
b. Removal. Refer to figure 4-111 and remove
the van body clearance lights.
4-159
