TM 5-4610-218-12
(4) Inspect the lamp holder base for cracks,
damaged wires and connectors.
semble the clearance lights.
(5) Inspect the lamp for broken filament.
d. Clean, Inspect and Repair.
(6) Replace the gasket at installation.
(1) Clean all parts with dry cleaning solvent
P-D-680.
(7) Replace the screws if damaged and all un-
(2) Inspect the door for cracks and rust.
serviceable parts.
(3) Inspect the lense and spring nuts for
(8) Replace an unserviceable clearance light.
cracks.
the van body clearance lights.
Figure 4-111. Van Clearance Lights, One With Door Removed, Removal and Installation.
4-87. Van Body Reflectors.
4-88. Van Body Ceiling Lights
a. General. There are two flush mounted 110
water purification van body, four red ones on the
volt ceiling lights. The door of each light is equipped
rear of the van body, and four amber ones on the
with torsion spring hinges and frosted glass.
front. All light reflectors are removed and installed
in the same manner.
the van body ceiling lights.
the van body reflectors.
c. Clean, Inspect and Replace.
c. Inspect and Replace. Replace a damaged re-
(1) Clean all parts with a clean dry cloth.
flector.
(2) Inspect the light frame assembly for
cracks, breaks, rust or other damage,
stall the van body reflectors.
4-164
