TM 55-1930-209-14&P-10
3-14.2.3
Searchlights
a
Turn searchlights OFF at rotary switch on searchlight base.
b
Redtag appropriate rotary switch with: "WARNING - DO NOT ACTIVATE - REPAIRS BEING MADE."
c
Open three quick-release latches and open front door of searchlight.
d
Remove burned-out bulb.
e
Clean reflecting mirror and inside of lens with fresh water
Wipe dry and polish.
f
Install new bulb, close door, and secure quick-release latches.
g
Turn light ON to make sure bulb works.
h
Remove red tag.
3-14.2.4
Shore discharge hose deployment status lights
a
Open (OFF) circuit breaker 5P14 on 24 Vdc power panel to turn off status lights.
b
Redtag appropriate circuit breaker with: "WARNING - DO NOT ACTIVATE - REPAIRS BEING MADE."
c
Unplug status light at topdeck and lower mast.
d
Loosen cover set screw Turn cover by hand counterclockwise and lift off. Clean with fresh water and wipe
dry.
e
Replace burned-out bulb.
f
Reinstall cover, turn clockwise, and tighten set screw.
g
Raise mast and plug light cord into receptacle.
h
Close (ON) circuit breaker 5P14 to make sure bulb works.
i
Remove red tag.
3-14.2.5
Anchor light
a
Open (OFF) circuit breaker 7P14 on 24 Vdc power panel to turn off anchor lights.
b
Redtag circuit breaker with: " WARNING - DO NOT ACTIVATE - REPAIRS BEING MADE."
c
Remove anchor light cover. Clean with fresh water and wipe dry.
d
Replace burned-out bulb.
e
Reinstall light cover.
f
Close (ON) circuit breaker 7P14 to make sure bulb works.
g
Remove red tag.
3-13
