3.
Wire the INCINOLET in accordance with the wiring
diagram shown in this manual. Metal conduit and
junction
box
must
be
used
in
accordance
with
Underwriters
Laboratory
and
Canadian
Standard
Association requirements. NOTE: Unit is grounded
through the green ground wire at the rear of the unit.
DO NOT install nor use the unit without providing
adequate ground according to this method. CAUTION:
UNIT MUST BE GROUNDED by means of conduit and
ground wire. Unit must be wired through 30 amp fuse or
circuit breaker.
INSTALL VENTLINE.
4.
Ventline is 4 inch diameter. single-wall construction.
and should be of corrosion resistant material such as
galvanized metal or stainless steel. Flexible. heavy-
duty. Neoprene coated line may also be used. provided
stainless steel hose clamps are used at each end of the
line to prevent leakage. Ventline joints within the toilet
room must be taped or otherwise sealed to prevent
leakage. Use caulking or tape around each ventline joint
including the elbow.
NOTE: DO NOT TERMINATE VENTLINE NEAR A
WINDOW OR FRESH AIR INTAKE
5.
After installation, with electric power applied, test the
circuit by initiating the incineration cycle.
a.
Heater warms.
b.
Blower comes on.
c.
Indicator light comes on.
OPERATION
HOW TO USE.
To use the INCINOLET properly:
1.
ALWAYS PLACE WAX PAPER LINER IN THE
BOWL BEFORE EACH AND EVERY USE.
2.
Flush
toilet
by
stepping
on
the
footpedal.
Incineration starts automatically on footpedal flushing.
TYPICAL CYCLE.
Length of incineration cycle may vary somewhat,
depending
upon
the
amount
of
waste,
room
temperature. heater wattage, voltage and whether
incinerator is already hot from a prior cycle.
4
