TM 55-1930-209-14&P-19
Table 2-4. Preventive Maintenance Checks and Services for Handling Equipment (Continued)
B -
Before
D -
Daily
Q - Quarterly
D -
During
W -
Weekly
S - Semiannually
A -
After
M -
Monthly
A - Annually
INTERVAL
ITEM
PROCEDURES
EQUIPMENT
ITEM
TO BE
CHECK FOR AND HAVE
IS NOT READY/
NO.
INSPECTED
REPAIRED OR ADJUSTED
AVAILABLE IF
B D A D W M Q S A
AS NECESSARY
f.
Check hook for free swivel movement.
Adjust or repair as necessary.
g. Inspect load chain for lubrication, wear,
Load chain dam-
damaged links, or foreign matter. Lubri-
aged.
cate, clean or repair as necessary.
h. Check hook block for damage, rust, or
Hook block dam-
corrosion. Clean as required.
aged.
i.
Inspect trolley track wheels for external
Tread and flange
wear on the tread and flange. Repair as
excessively worn.
necessary.
j.
Inspect chain guides for wear or burring
Chain guides show
where chain enters hoist. Replace
severe wear or
severely worn guides.
burring.
NOTE
Lubricant
Location
Instructions
NLGI No. 2 Grease
Fittings on chain sheave
Annually or as required.
pins (roller bearings)
* Trolley wheels
After prolonged use or at
reassembly
Pawl Stud
Coat lightly at reassembly
Brake square thread
Coat lightly at reassembly
NLGI No. 2 with
Gears
After prolonged use or at
E.P. additive
reassembly
Intermediate oils
Chain
Immerse in container or
preferably with
swab with oil soaked rag.
E.P. additives
Wipe off excess oil. Should
maintain chain rust free.
Bonded lubricants
Chain
Use in place of oil, if oil
(similar to Dow
residues are objectionable.
Molykote M-88)
* Not required on units equipped with sealed ball bearings. (Wheels will not have grease fittings.
See also service lubrication specifications contained in MIL-L-2104 and MIL-L-46152)
13-13
