TM 55-1930-209-14&P-21
NOTE
Minor variations in thickness of pads are possible. More than an 1/8 inch variation indicates that
drum or bands are out of round or that brake band set screws have been improperly adjusted.
(4)
Examine remaining hardware for discrepancies. Pay particular attention to brake band retaining pins and
brake arm pins. Clean excess grease and dirt off pins.
(5)
Inspect pin lube lines for signs of damage.
d.
If inspection indicates no discrepancies, do not perform any more maintenance except to adjust brakes as
required. Refer to paragraph 3-11.
4-20. Drum Brake Installation
a.
Install drum brake bands in reverse of removal sequence.
b.
Adjust brake bands as in para 3-11.
c.
Install the brake drum dust cover.
4-20
