TM 55-1930-209-14&P-21
26. Shaft -Operating
32. Screw
27. Lever - Operating Shaft
37. Guide -Plunger
Figure 6-3. Removing Variable Speed Spring Plunger Guide.
k.
Disassemble governor weight housing as follows:
(1)
Place weight housing (Figure 6-4) in soft jaws of a vise. Remove end plug and gasket.
(2)
Straighten tang of lockwasher and remove bearing retaining bolt.
(3)
Thread a 5/16in-24 x 3in bolt into tapped end of weight shaft. Support weight housing on bed of press as
shown in Figure 6-5, then press shaft from bearing.
(4)
Slide riser thrust bearing and governor riser from shaft. This bearing is specially designed to absorb thrust
load; therefore, looseness between mating parts does not indicate excessive wear.
(5)
Remove bearing from weight housing.
(6)
Use a removal tool and remove one lockring from each weight pin. Withdraw pins, flatwashers and
governor weights.
(7)
If required, weight carrier (Figure 6-4) may be pressed from governor weight shaft and a new carrier
installed.
6-7
