TM 55-1930-209-14&P-21
Figure 6-7. Installing Speed Control Shaft Bearings in Spring Housing.
6-9 Governor reassembly and installation
a. Governor cover reassembly
(1) If new needle bearings are to be installed in governor cover, place governor cover on bed of an arbor
press with inner face of cover down. Start a new needle bearing straight into the bearing bore of the cover with bearing
number up. Then insert bearing installer in bearing and press bearing in until shoulder on tool contacts cover.
(2) Reverse governor cover on bed of press (inner face of cover up). Start second bearing straight into bore
of cover with bearing number up. Press bearing in flush with cover.
NOTE
Do not use impact tools to install needle bearings.
6-12
