TM 55-1930-209-14&P-6
Table C-1. Preventive Maintenance Checks and Services for Shore Discharge System (Continued)
B - Before
D - Daily
Q - Quarterly
D - During
W - Weekly
S - Semiannually
A - After
M - Monthly
A - Annually
Interval
Procedures
Item
Check For And Have
Equipment
Item
To Be
Repaired Or Adjusted
Is Not Ready/
No.
B
D
A
D
W
M
Q
S
A
Inspected
As Necessary
Available If
WARNING
Pressure should not exceed 4000 psl.
3)
Pump until hand brake piston enters
cylinder and band is tight on brake
drum.
4)
Position valve SD3 in NEUTRAL posi-
tion (midway between OPEN and
CLOSE position) to lock the cylinder in
the set position.
11
Buoys
Check that buoys are in place. Replace if
missing.
12
Status Signals/
Check that status signal/lights are dis-
Any light is
Lights
played as follows on top of deckhouse
inoperable
center most:
Bottom
Time
Top Signal
Middle Signal
Signal
Daytime
Black Ball
Black Diamond
Black Ball
Nightime
White Light
Red Light
White Light
CAUTION
Roughness on steel chute surfaces could
damage hoses.
13
Steel Chute
Check that surfaces are smooth and free of
Surfaces
gouges, damage, or roughness. Repair as
(weatherdeck aft)
necessary.
14
Reduction
a.
Check fluid level in levelwind reduction
Fluid level low
Gear Boxes
gear boxes as follows:
NOTE
If oil cannot be filled thru breather hole,
Install street elbow in hole to aid In filling.
1)
Remove oil level plug in gear box
located on portside of levelwind.
2)
Check oil level. Oil level must be near
bottom of oil level plug hole.
3)
If Gulf Harmony 43 AW or military
equivalent oil has to be added,
remove breather plug.
4)
Fill slowly thru breather hole until oil
begins to drain from oil level plug.
C-8