MOUNTING COMPRESSOR PULLEY
NOTE:
DRIVE WEDGE (E.G. METAL WORKING
CHISEL) IN THE SLOT TO SPREAD HUB
SHOULD BE SPREAD ONLY END TO
SLIDE OVER CRANKSHAFT. (CAUTION:
EXCESSIVE SPREADING OF HUB COULD
CAUSE FRACTURE.)
FLYWHEEL MUST BE MOUNTED WITH
SPLIT HUB BOLT HOLE AWAY FROM
PUMP. FLYWHEEL SHOULD BE
POSITIONED WITH HUB 1/16 IN FROM
SHAFT END (SEE SKETCH).
ALIGN KEYWAYS ON SHAFT AND
FLYWHEEL HUB AND INSERT KEY.
REMOVE WEDGE.
INSTALL NUT AND BOLT; THEN TIGHTEN
FLYWHEEL HUB TO SHAFT. TORQUE
BOLT TO APPROXIMATELY 500 IN LB.
