Every 10 Service Hours
5.
Clean the three sealing surfaces 1 on the base 2
with a clean cloth.
6.
Install the new element () to the base by first
inserting the roll pin i) into the outlet passage at the
bottom of the base. Align the filter holes with the base
holes, and push the element into place.
7.
Place the lower tab of the clamp in the bottom
locking slot of the base. Push the upper tab into the
locking slot at the top of the base. Make sure clamp is
securely engaged in the top and bottom locking slots.
8.
Open the fuel valve and start the engine. It may be
necessary to prime the fuel system if the engine does not
start. Inspect for fuel leaks.
5 Cooling System-Check Coolant Level
At Operating Temperature, engine coolant is hot and
under pressure.
Steam can cause personal injury.
Check coolant level ONLY when engine is stopped
and filler cap is cool enough to touch with your
hand.
Remove filler cap slowly to relieve pressure.
Cooling System Conditioner contains alkali. Avoid
contact with skin and eyes to prevent personal
injury.
If it is necessary to add coolant daily, inspect the cooling
system for leaks.
6 Clutch Shift Collar
1.
Inspect coolant level with the engine stopped and
cold. Remove the radiator cap slowly to relieve
pressure. Observe the coolant level.
2.
Maintain coolant level within 1 cm (1/2 inch) below
the top of the fill pipe. Inspect cap gasket and replace if
necessary.
Lubricate 1 fitting.
42
