Engine
Disassembly and Assembly
Governor
35.
Use tooling (D) to install the lip type seal in cover
(73) with the lip in as shown.
36.
Put the gasket and cover (73) in position on the
housing, and install the bolts that hold it in place.
37.
Install seat (74) and spring (75) on guide (76).
Make sure the seat and spring are on top of the lever.
NOTICE
Make sure the spring and seat are on top of the lever
when housing (77) is installed.
38.
Put the gasket and housing (77) in position on
the inner governor housing, and install the nine bolts that
hold it in place.
39.
Put service meter (78) in position, and install
clamps (79) and the bolts that hold them.
40.
Adjust the governor. See Governor Adjustments
in Testing And Adjusting.
END BY:
a.
install fuel injection pump housing and governor
30