Engine Disassembly and Assembly Crankshaft Rear Seal And Wear Sleeve Remove Crankshaft Rear Seal And Wear Sleeve 1161-011 Tools Needed A B C IP3075 Puller Group 1 5P7312 Distorter 1 5P7313 Ring 1 START BY: a. remove flywheel 1. Use tool (A) to remove the crankshaft rear seal. 2. Install tool (C) in the rear seal bore, and install tool (B) between tool (C) and the wear sleeve. Turn tool (B) until the  ends  of  the  tool  make  a  flat  place  (crease)  in  the wear sleeve. Do this in two or more places until the wear sleeve is loose. 3. Remove tool (C) and the wear sleeve by hand. Install Crankshaft Rear Seal And Wear Sleeve 1161-012 Tools Needed A 9S8871 Locator 1 9S8858 Nut 1 9S8890 Bolt 1 5P7298 Installer (Earlier Type Seal) 1 6V7876 Installer (Later Type Seal) 1 NOTICE Do not make a separation of the later type seal and wear sleeve or damage to the seal will result. 1. Install the crankshaft rear seal and wear sleeve with tooling (A) as follows: a. Put   locator   (1)   in   position   on   the   crankshaft,   and install the three bolts that hold it in place. b. Put clean engine oil on the seal lip of seal (6) and on the outside diameter of wear sleeve (2). 123