TM 10-4610-215-10
TM 08580A-10/1
LEGEND:
1. R.O. Elements
2. Interconnector
3. R.O. Vessel
4. End Connector
Figure 3-9. Element Replacement
(14) Place 10 washers and nuts onto studs.
CAUTION
65 in. lb (5.4 ft. lb) is maximum torque for end cap nuts. Do not exceed this
torque.
(15) Slowly and evenly tighten nuts until handtight (snug). Never turn one nut more than two turns
at a time. Once handtightened, evenly tighten each nut 1/8 turn with wrench.
(16) Reconnect pipes to R.O. vessel (fig. 3-1).
(a) Put hose clamp (1) over tubing (2). Place tubing (2) and clamp (1) over adapter (13) and
tighten clamp (1).
(b) Place bushing (6) back on pipe.
(c) Swing elbow (7) back into place and put onto bushing (6) over elbow (7).
(d) Put clamp (5) over bushing (6).
(e) Put bolts (4) into clamps (5).
(f) Put nuts (3) on bolts (4) and tighten.
(17) Operate ROWPU (para. 2-24) and observe for leaks.
3-5.
CHANGING CARTRIDGE FILTER TUBE ELEMENTS. (Model No. 600-1, refer to fig. 3-10. Model
No. 600-3, refer to fig. 3-11.)
3-25
