TM 10-4610-215-24
TM 08580A-24/2
NOTE
Mark fan-end plate, pump-end plate, and motor casing with
matching punch pricks to assure proper alignment during
assembly.
(13) Remove four through-bolts (8) from pump-end plate (12), motor casing (18), and fan-end plate (9).
(14) Strike fan-end plate (9) with a soft-faced mallet to break its bond to the motor casing (1 8). Remove
fan-end plate (9) from motor casing (18).
(15) Remove wavy washer (10) and flat washer (11) from shaft (14).
CAUTION
Motor casing wiring can be snagged or broken on rotor shaft.
Take care not to damage wiring when removing rotor shaft.
(16) Strike pump-end plate (12) with a soft-faced mallet to break its bond to the motor casing (18).
Remove pump-end plate (12) with rotor shaft (14) attached, from motor casing (18).
(17)
(18)
(19)
(20)
(21)
Remove two screws (13) from bearing retainer (16) and pump-end plate (12).
Remove rotor shaft (14) from pump-end plate (12).
Using a bearing press/puller, remove pump-end bearing (15) from rotor shaft (14).
Remove bearing retainer (16) from rotor shaft (14).
Using a bearing press/puller, remove fan-end bearing (17) from rotor shaft (14).
c. Cleaning.
WARNING
Objects blown by compressed air can cause serious eye injury.
Always wear protective goggles when using compressed air.
(1) Blow out dirt inside motor casing with compressed air.
3-53
