TM 10-4610-215-24
TM 08580A-24/2
(25) Hold conduit box cover (2) in place on conduit box (5) and align two mounting holes.
(26) Install two screws (1) through conduit box cover (2) and conduit box (5).
i. Reassembly. (Figure 3-10) (USMC)
(1)
(2)
(3)
(4)
casing (8).
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(18).
(13)
(14)
(15)
(16)
Connect two wire clips of capacitor (28) and install capacitor (28) on motor casing (8).
Hold gasket (27) and capacitor cover (26) in place on motor casing (8).
Install two screws (25) through capacitor cover (26), gasket (27), and motor casing (8).
Connect two wire clips to stationary switch (24) and hold stationary switch (24) in place on motor
Install two screws (23) through stationary switch (24) and motor casing (8).
Install centrifugal mechanism (22) on rotor shaft (10).
Press front-end bearing (21) on rotor shaft (10).
Install bearing retainer plate (18) on rotor shaft (10).
Press pump-end bearing (20) on rotor shaft (10).
Install shaft seal (19) on rotor shaft (10).
Install pum-end plate (13) on rotor shaft (10).
Install two screws (16) through two washers (17), pump-end plate (13), and bearing retainer plate
CAUTION
Motor casing wiring can be snagged or broken by rotor shaft.
Take care not to damage wires when installing rotor shaft.
Align prepunched indexing marks on pum-end plate (13) and motor casing (8).
Install rotor shaft (10) with pump-end plate (13) attached, in motor casing (8).
Install spacer (15) on front-end plate (14).
Align prepunched indexing marks on front-end plate (14) and motor casing (8).
3-49
