TM 10-4610-21 5–24
TM 08580A-24/2
(9)
(10)
(11)
(12)
(13)
(14)
(15)
(16)
(17)
(18)
(19)
(20)
(21)
(22)
(23)
(24)
Install bearing-snap ring (17) on rotor shaft (15).
Press pump–end bearing (16) on rotor shaft (15).
Install rotor (15) in pump-end plate (14).
CAUTION
Motor casing wiring can be snagged or broken by rotor shaft.
Take care not to damage wires when installing rotor shaft.
Align prepunched indexing marks on pump-end plate (14) and motor casing (27)
Install rotor (15) with pump-end plate (14) attached, in motor casing (27).
Install three spacers (13) in fan-end plate (12).
Align prepunched indexing marks on fan–end plate (12) and motor casing (27).
Install fan–end plate (12) on motor casing (27).
Install four through bolts (11) through fan–end plate (12), motor casing (27), and pump-end plate (14).
Slide fan (10) over rotor shaft (15).
Tighten clamp screw on fan (10).
Slide fan cover (9) over motor casing (27).
Install four screws (8) through fan cover (9) and motor casing (27).
Install shaft key (7) in rotor shaft (15).
NOTE
Secure shaft key in position with tape, wire, or similar method to
avoid loss.
Hold conduit box (5) and new gasket (6) in place on motor casing (27) and align two mounting holes.
Install two screws (3) and two lockwashers (4) through conduit box (5) and motor casing (27).
3-48
