(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
TM 10-4610-215-24
TM 08580A-24/2
Install new gasket (18), disc retainer (11), disc (12), and disc plate (19) onto shaft (4).
Using a screwdriver to hold shaft (4), install lockwasher (14) and nut (13) onto shaft (4)
Install small O-ring (10) into O-ring retainer (8).
Slide O-ring retainer (8) with large O-ring (9) over shaft (4).
Carefully lower shaft (4) with O-ring retainer (8) attached, into valve body (3).
Slide gasket (18), lower plate (6), diaphragm (7), upper plate (6), and gasket (18) onto shaft (4).
Position diaphragm (7) on mounting flange of valve body (3).
Using a screwdriver to hold shaft (4), install nut (5) onto shaft (4).
NOTE
Make sure diaphragm is seated flat, with no folds or wrinkles.
Make sure no foreign matter is trapped on diaphragm or mating
surfaces.
(10) Carefully position cap (2) over diaphragm (7) and align mounting holes.
(11) Install four screws (1) through cap (2) and valve body (3).
(12) Install elbow (17) into cap (2).
p. Reassembly, Multimedia Filter Control Valve Assembly. (Figure 3-41)
NOTE
Procedures for reassembly of cartridge assembly is typical for six
valves on the control valve assembly.
(1) Install O-ring (10) and pipe plug (9) into valve body (3).
(2) Install O-ring (11) and all parts to cap assembly (8) into valve body (3).
(3) Install seat gasket (7) and seat (6) into valve body (3).
(4) Install cartridge gasket (5) into valve body (3).
3-175
