TM 10-4610-229-24
3-47. TURBOCHARGER ASSEMBLY REPAIR (CONT)
23
Remove shroud.
24
Remove snapring.
25
Remove sleeve.
26
Remove snapring.
27
Clean bearings.
28
Inspect all parts for wear, cracks, and other damage. Replace as required.
b.
Assembly
1
Lubricate all metal parts with engine oil (MIL-L-2104).
2
Install snapring on turbine wheel shaft with round side of snapring facing out.
3
Install sleeve.
4
Install snapring.
5
Install shroud. Make sure shroud is down on turbine wheel housing.
6
Turn cartridge housing over.
7
Install snapring.
CAUTION
To prevent bearing failure, make sure oil holes in bearing are open and clean.
8
Install bearing in housing.
9
Install snapring with round side next to bearing.
10
Install cartridge housing.
11
Install two pins in cartridge housing.
12
Install snapring.
13
Install bearing in housing.
14
Install snapring with round side next to bearing.
15
Install sleeve in housing.
3-106