TM 10-4610-229-24
3-47. TURBOCRARGER ASSEMBLY REPAIR (CONT)
CAUTION
To prevent bearing failure, make sure oil holes in bearing are open and clean.
16
Install ring, bearing, ring, and deflector in housing.
17
Install seal rings on sleeve.
18
Install sleeve in insert.
19
Install insert in housing. Install seal ring and snapring.
20
Fill seal ring groove to over half the depth of groove with silicone grease.
21
Lubricate shaft with engine oil (MIL-L-2104).
CAUTION
When shaft nut is not tight, do not put a side force on the shaft.
22
Install shaft in cartridge housing.
23
Install compressor wheel on shaft.
24
Coat threads of shaft with engine oil (MIL-L-2104).
25 Install compressor wheel nut. Torque nut to 20-24 ft lb.
26
Aline marks on cartridge housing and turbine housing. Install cartridge housing in turbine housing.
27
Install V-clamp. Tighten clamp.
28
Install seal on cartridge housing.
29
Aline marks on cartridge housing and compressor housing. Install compressor housing on cartridge housing.
30
Install V-clamp. Tighten clamp.
31
Mount turbocharger to workbench.
32
Loosen V-clamp nuts.
33
Torque V-clamp nuts 110-130 in. lb.
3-107
