TM 10-4610-229-24
3-48. STARTER REPAIR (CONT)
11
Slide a 1/2 in. pipe coupling or cylinder of suitable size over end of shaft so end of coupling or cylinder butts
against edge of retainer.
12
Tap end of coupling or cylinder with a hammer, driving retainer towards armature and off snapring.
13
Remove snapring from shaft. Remove retainer.
14
Remove the armature and clutch from housing.
15
Separate solenoid from lever housing by pulling apart.
16
Remove plug from lever housing. Remove and discard gasket.
17
Remove snapring, seal, shaft, and snapring from lever housing.
3-112