TM 10-4610-232-12
WARNING
Make sure load hook is attached at or near balance point of any load being moved. Failure
to do so could result in violent swinging or dropping of load. This could result in serious
injury and damage to equipment.
WARNING
Crewmember on ground should stand clear of pump frame to avoid being hurt in event
pump falls or is released too quickly.
WARNING
Check chains on hoist for link damage or wear regularly. Damaged or worn chains must be
replaced immediately to prevent accident. Notify unit maintenance.
(42)
Disassemble access ladder (Figure 2-65), distribution side.
(a)
Remove handrails (1).
(b)
Unhook snap hooks and remove chains (2) from stake pockets (3) on trailer.
NOTE
Ensure that the distribution pump power cable is neatly rolled and placed inside the pump
assembly frame. Do not disconnect the power cable from the pump assembly.
(43)
Attach chain hoist (1, Figure 2-66) to eyebolt (2) over distribution side access door and to eyebolt on distribution pump (3).
Using chain hoist, lift the distribution pump into van and position distribution pump with drain pipe facing door.
(44)
Disconnect chain hoist hook and take down chain hoist from eyebolt and rehook at front door as shown in Figure 2-67.
(45)
Using generator ladder, store anchor (56) (Figure 2-64, Sheet 3), anchor rope (57), and stool (58) (upside down) on top of
distribution pump (59).
Figure 2-65. Loading the Ladders
2-134 Change 12
