TM 10-4610-232-12
Figure 4-29. Electrical Installation (sheet 6 of 8) Primary Harness, Back Wall, W-33
REASSEMBLY.
a. If utility light cable (11, Figure 4-29, sheet 8, View D) was removed, proceed as follows:
(1) Install housing (19) with two capscrews (16), lockwashers (17) and washers (18).
(2) Place nut (12), retainer (13) and bushing (14) on cable (11).
(3) Install connector body (15) into housing (19).
(4) Insert cable (11) through body (15) and the hole in housing (19). Push enough wire to enable easy connection to
socket (5).
(5) Place gasket (10) on housing (9).
NOTE
The holes in housing are slotted to allow some adjustment, if required.
(6) Install housing (9) on housing (19) using screws (8):
(7) Install socket (5) on bracket (7) using two screws (4).
4-130
