TM 10-4610-232-12
Figure 4-29. Electrical Installation (sheet 7 of 8) Primary Harness, Front Wail, W-33
( 8 ) Connect the two wires from harness (11) to socket (5). Spray or brush on varnish conforming to MIL-V-173 on
electrical connections.
(9) Install bracket (7) with socket (5) in housing (9) and secure with screws (6).
(10) Slide bushing (14), retainer (13) and nut (12) onto elbow (15) and tighten nut (12).
(11) Install lamp (3), gasket (2) and globe (1).
b. Install the 24 VDC power input cable (Figure 4-29, sheet 3, View B) as follows:
(1) Insert the connector of cable (4) through the ROWPU wall from inside the ROWPU with gasket (5) in place.
(2) From outside the ROWPU, insert four screws (2) through dust cap (3) chains, gaskets (5) and the flange of cable
(4) connector and secure the cable connector to the wall of the ROWPU with nuts (1).
(3) Connect cable (4) to the power supply.
(4) Install tie wraps (para. 4-10).
c. Reinstall all cables except the 24 VDC input power cable (Figure 4-29, sheet 3) as follows:
4-131
