TM 10-4610-232-12
a. Replace unserviceable parts.
b. Replace nameplates, wire markers, and wire ties that were removed during disassembly (para. 4-10), if
necessary.
c. Repair damaged or loose ring tongue terminals by replacement (para. 4-10).
a. Install subpanel (47, Figure 4-34). Secure with capscrews (46), Iockwashers (46A) and washers (46 B).
b. Install rail (45) and secure with Iockwasher (44) and capscrew (43).
c. Refer to para. 4-10 and install terminal strips. Install end plates, retainers (38) on rail (45) and secure with
capscrew (37). Install jumpers (41) as tagged during removal and replace markers (42) if removed.
d. Install wiring harness (31) and gasket (35) and secure with capscrews (32), nuts (33) and washers (34) and
washers (34A). Connect wires to terminal board (36) in accordance with markings.
e. Install wiring harness (26) and gasket (30) and secure with capscrews (27), nuts (28) and Iockwashers (29) and
washers (29A). Connect wires to terminal board (36) in accordance with markings.
f. Install wiring harness (21) and gasket (25) and secure with capscrews (22), nuts (23) and Iockwashers (24) and
washers (24A). Connect wires to terminal board (36) in accordance with markings.
g. Install tWO alarms (20) and secure with two ring nuts (19), two washers (19A) and six spacers(19B),
h. Install receptacle(18) and secure withcapscrews(14), nuts (15), Iockwashers(16) and washers (17). Install dust
cap (13) and secure with capscrew ( 12).
i. Install spacers (10) on switch (9), and secure the switch with lock ring (7) and nut (6). (11)
j. Install spacers (10) on switch (9) and secure switch with lock ring (2) and handle (1).
k. Connect wires to fan and mixer switch (4), light switch (9), two alarms (20) and receptacle (1
markings made during disassembly. Spray or brush varnish on the wire connections.
DELETED.
8) in accordance with
l. Install the other ends of the wires to the terminal strip (36) as tagged during disassembly (para. 4-10).
a. Refer to Figure 4-33 and install switch panel No. 2 as follows:
(1) Install panel assembly (16) on wall by securing with washers (15), Iockwashers(14) andcapscrews(13).
(2) Install cable adapter with sealing washer (11) and secure with conduit nut (12).
(3) Slide connector nut (8), retainer (9) and bushing (10) on wiring harness (7). Insert wiring harness through cable
adapter (11). Tighten connector nut (8).
(4)
(5)
(6)
Connect wires from wiring harness (7) to terminal strip(17) as tagged during disassembly (para. 4-10).
Install cover (6) on enclosure (16). Secure with clips (5) and screws (4).
Install connectors (1, 2 and 3).
Change 2 4-145
